Wanna know how to automatically battle common tribes without lifting a finger?
Newbies Guide to Auto-Battle
By Arcane Ŋyx
Hey all! I have to admit, I was manually battling those pesky tribes for ages. I had no idea there was an auto-battle feature! I lost out on so much time and rewards because of it.
But don’t worry, I’ve learned from my mistakes, and I’m here to share my knowledge with you! In this guide, I’ll walk you through how to use the auto-battle feature, so you can save time and maximize your rewards.
What is Auto-Battle?
Auto-battle allows your troops to attack barbarians automatically until stamina runs out. It’s a total game-changer!
Setting Up Auto-Battle
- Choose barbarian level and type.
- Set Minimum Units in Troop (70-80%) and Hospital Capacity (70-80%).
- Select single or multiple marches.
- Click Auto Battle.
Key Considerations
- Barbarian Level: Lower levels for solo marches, higher levels for multiple marches.
- Barbarian Type: Choose based on your team’s counter units.
- Archers counter Swordsmen.
- Swordsmen counter Pikemen.
- Pikemen counter Cavalry.
- Cavalry counter Archers.
- Alliance Coins/Funds: Attack each barbarian with single march for maximum rewards.
- Hospital Capacity: Keep below 100% to avoid troop loss.
Multiple March Selection
- Click Multi Select (left side).
- Select/deselect heroes as needed.
- Click Auto Battle.
Tips & Tricks
- Adjust settings based on stamina and marches.
- Experiment with different strategies.
- Keep hospital capacity below 100% to avoid troop loss.
Be the first to comment